Special tools for engines and gearboxes

65474170 Special circlip pliers

for removing and fitting the output shaft circlips, as well as the economical operation of the gearboxes (all GETRAG gear units, and ZF-gearboxes S4-18 / 3).
-
weightkg
-
mm

74480000 Clutch centering tool

8-piece set. Contents:
1 pc centering pin of the coupling, length 220 mm
1 pc combined sliding cone / cylinder, graduated cylinder, 22.2-25.2 mm
1 pc sliding cylinder, graduated from both sides, cylinder diameter 16-21 mm
5 pcs cylindrical handle, each in two sizes, cylinder diameter 12-20 mm; all in a wooden box 255 x 81 x 38 mm.
-
weightkg

71170011 Counter stay

-
weightkg

8130027 Bits

for screws with internal TORX®, size T27, square hole for 1/4 "drive; used for tightening switches of automatic transmissions 3HP 22, 4HP 22.
-
performance
-
weight6 kg
-
mm

71160012 Counter stay

Wingspan 20-27 mm, which is used for the bearing wheel of the guide wheel on the drive wheel of the oil pump with support No. 11061-2.
-
weightkg

44700018 Pin wrench

bent, pin spacing 18 mm, pin diameter 2.9 mm, length 140 mm; application: for tensioner pulley of diesel engine drive belt size 1.6l.
-
weight76 kg

58240005 Square drive insert tools

square hole for 3/8 "drive,
used together with torque wrench No. 730/2 SERVICE-MANOSCOP®.
-
weight76 kg
-
mm
-
mm

71160021 Internal pullers

clearance range 16-20 mm, for sealing rings and deep groove ball bearings of crankshafts; use together with counter support No. 11061-1.
-
weightkg

58250010 Ratchet insert tool

switchable; clamping square 1/2 ".
-
weightkg
-
mm
-
mm